ZenPacks : Dell EqualLogic Monitor : Comments

RE: Dell EqualLogic Monitor

community@zenoss.org — Thu, 27 Jan 2011 19:41:17 GMT

Eric,

I got this to work, however, we have two EQLs in a pool, with one management address. Only one set of ethernet interfaces shows up. I get both sets of disks and fans, though. Also, the three interfaces which *do* show up (eth0,1,2 from master) are not showing any data on the graphs. I would love to help you extend this Zenpack, test it, whatever, just let me know.

Thanks!

Tim

RE: Dell EqualLogic Monitor

community@zenoss.org — Fri, 04 Feb 2011 16:09:59 GMT

After installing this, I've been getting error events like the one below from zenoss.

Unhandled exception in zenhub service ZenPacks.zenoss.ZenJMX.services.ZenJMXConfigService.ZenJMXConfigService: 'DellEqualLogicDevice' object is unsubscriptable

Traceback (most recent call last): File "/opt/zenoss/Products/ZenCollector/services/config.py", line 84, in _wrapFunction return functor(*args, **kwargs) File "/opt/zenoss/ZenPacks/ZenPacks.zenoss.ZenJMX-3.5.2-py2.6.egg/ZenPacks/zenoss/ZenJMX/serv

RE: Dell EqualLogic Monitor

community@zenoss.org — Wed, 08 Jun 2011 19:00:30 GMT

I've got the zenpak installed and its working pretty well. Two problems:

- The configured threshold values for the fan speeds (e.g. here.highThreshold) cause an error when viewing graphs: User-supplied Python expression (here.highThreshold) for maximum value caused error: ['rpm_rpm']

- If I look at Fan graphs, they're all 'nan'. But if I test the data point query against a device, I get values returned.

RE: Dell EqualLogic Monitor

community@zenoss.org — Wed, 19 Oct 2011 17:18:38 GMT

hello,

i am trying to create some graphs for the volumes, but i cannot find where you have the volumes defined in the template.

Under templates i was able to find the HardDisk remplate and the Fan template. Where do you have defined the volumes? i would like to create some graphs for them.

Please let me know if you get a chance.

Thank you