ZenPacks : APC Power Distribution Units (PDU) : Comments

RE: APC Power Distribution Units (PDU)

community@zenoss.org — Wed, 09 May 2012 10:16:35 GMT

I use AP7852 B2 and keep getting alert:

threshold of powerSupply2Thresh exceeded: current value 3.00

It seems to be looking for Power Supply 2 status which we don't have/use.

Is there a way to disable the monitoring for this component without taking it all off?

Cheers,

RE: APC Power Distribution Units (PDU)

community@zenoss.org — Wed, 09 May 2012 18:56:15 GMT

If you navigate to the APC PDU Power Supplies component and then change the Display dropdown to template, you will see the COMPONENT template that is automtically bound, along with thresholds for PowerSupply1Thresh and PowerSupply2Thresh. If you don't use the second power supply on any of your APC PDU devices, then you could change the master template and simply untick the Enabled flag on that second threshold. If you want to change this for a single device then use that Templates dropdown to "Create Local Copy" of the template and do the change just for that device.

Does that work for you??

Cheers,

Jane

RE: APC Power Distribution Units (PDU)

community@zenoss.org — Thu, 02 May 2013 18:43:58 GMT

Hi guys,

I do not think this is compatible with 4.2.3 ??

I tried installing it but no luck.

thank you