Archived community.zenoss.org | full text search
Skip navigation
Currently Being Moderated

24.3 3 Enable Monitoring

VERSION 1 
Created on: Oct 26, 2009 4:27 PM by Zenoss API - Last Modified:  Oct 26, 2009 4:27 PM by Zenoss API

#24.3. Enable Monitoring

Follow the steps in this section to configure your Cisco device and Zenoss for monitoring.

#24.3.1. Configuring Cisco Devices to Allow SNMP Queries

Configure the Cisco device to allow SNMP queries from the Zenoss server, and send SNMP v1 or SNMP v2 traps to the Zenoss server.

#24.3.2. Configuring Zenoss

All Cisco devices must be located in the /Devices/Network/Cisco device class.

  1. Navigate to the device or device class (if configuring multiple devices) in the /Devices/Network/Cisco device class in the Zenoss interface.

  2. If applying changes to a device, click the page menu, and then select MorezProperties.

    If applying changes to a device class, click the zProperties tab.

  3. Edit the appropriate zProperties for the device or devices.

    #

    Table 24.2. Cisco zProperties

    NameDescription

    zSnmpCommunity

    Consult with your network administrators to determine the SNMP community permitted.

    zSnmpMonitorIgnore

    Set to a value of False.

    zSnmpPort

    The default port is 161.

    zSnmpVer

    Set to a value of v2c.


  4. Click Save to save your changes. Zenoss now will collect Cisco device metrics from the configured device or devices.

  5. Navigate to the Perf tab to see some place holders for graphs. After approximately 15 minutes, the graphs will begin to be populated with information.

Comments (0)